Hello
I would like to display an unfolded view of a sheet metal part but I must have a problem in a parameter...
The unfolded state gives me the following plan...
Usually it works...
Anyone have an idea?
Thanks in advance
What version of SW are you on?
Can you post the part?
may the force be with you.
1 Like
It's a sheet metal part, it looks like a sheet metal thickness problem
@+
I used the same procedure to make a similar part and this time, it works...
I don't really understand why...
I don't understand, I have no problem.
Do a test again I did the unfolded configuration.
may the force be with you.
tole_3000_obiwan.sldprt
1 Like
Hello
In your "flat-pattern" part configurations, your parts are not unfolded. See attached doc
So unfold your part in the "flat-pattern" config, then go back to your default config.
Your part will be for the drawing see doc-attached.
Good luck
capture.png
5 Likes
Yes, the unfolded state works in the 3D view but when I start from the base part to make a drawing, I am not in the unfolded view.
I have several views and the one of the unfolded state is wrong...
Ah! Indeed, it came from this "flat-pattern", I had to modify something without meaning to, usually I don't touch it and it's done automatically ^_^
Thank you all for your speed!
Have a great weekend
2 Likes