Round tubular structure fit

3D Design
1

Hello

I have a round tube structure of 30 to do, each tube will be cut with a laser, so that each wolf's mouth adapts to the best. But on the extremities the adjustment extends and creates too much of a void, I did make an adjustment and not to the bodies and not to the face. How would you do it?

 

2

Hello

Can you share your file so we can take a look at it?  

1 Like
3

@benjamin.leray 

how do you proceed

we can't see well via your creation tree

it's too vague

@+

1 Like
4

The 2020 SW Roomsp4


structure_meuble_cuisine.sldprt
5

the same in step


structure_meuble_cuisine.step
6

I found a solution but if you have faster I'm all for it.

I created my outer tubes in another function so that it doesn't adjust automatically. I then created a material removal at the axis of my tube to remove the material only on half of my tube, what do you think?

7

It doesn't give me your way of proceeding 

via the step no creation tree

and as you are in 2020 version and me 2017

I can't open your file

So it's ?

mechanically welded

blending 

in multibody

@+

 

8

I am a mechanically welded, I have created several sketches to have the skeleton of my part

9

You can do this by changing the order of the adjustments.

According to the attached photo, in your file you did:

- Tube 2 adjust from tube 3 and 1 which gives you the vacuum at the back of tube 3

If you don't want the vacuum, you have to adjust tube 1 in relation to tube 2 and 3, and then adjust tube 2 in relation to tube 3

 

 

 


tubes.png
2 Likes
10

You can also keep your method by simply unchecking "Allow to extend"


tubes_2.png
1 Like
11

Thank you very much @c.bellemin-menard