Hi everyone
How to improve the contour of a circle after bossing! (too much straight part)
A + Pierrot
essai_rond.sldprt
Hi everyone
How to improve the contour of a circle after bossing! (too much straight part)
A + Pierrot
Hello
Can you put a picture please?
Especially since we can access their software during the weekends!
Hello Pierrot!
Wouldn't it be a problem of resolving the sketch?
You should be able to adjust this in the settings (see attached image).
Have a nice weekend
Yann
Hello
There are 3 options for managing display quality in SolidWorks 2014, in Tools > Options > System Options:
Display / selection: Adjust the anti-aliasing.
Performance: Curve generation and level of detail just below.
With all these settings at maximum, the image will look better, but the PC may be a little slower...
Hi @ pierrot
the answers of @ lespetitspieds @ Lucas
I think I will solve your problem
The resolution is also proportional to the size of your room
@+ ;-)
Hi everyone
Here is my question has been answered and my problem is solved (by Lespetitspieds) thank you again!
Have a nice day