Real Appearance & SW

3D Design 3D Animation and rendering
1

Hello

Is it possible to differentiate for a material the actual appearance with Realview or Photoview360 from the appearance in Solidworks?

The goal is to put a yellow color in Solidworks for 316 stainless steel in order to differentiate it from 304 in Solidworks. (so as not to mistakenly throw coins in 316 instead of 304)

On the other hand, the sales department that does some rendering using Photoview 360 will surely complain if they have to go back to everything piece by piece to make the real rendering.

2

Hello

You should test with a configuration.

One that will be a workshop and the other will be commercial rendering

Cdlt

4 Likes
3

Rather display state than configuration.

But it quickly turns into a mess if you're not careful: you can associate or not the display states with the configs.
In your case, it would seem wise not to combine them.

2 Likes