Axis in a cone

Out of category
1

Hello

I can't place an axis in a cone because it has its sketches that are not parallel to this axis, not easy to explain, here is a screenshot.

I need this axis to make a constraint with another cone.

I am on SW2013

diiity


capture.jpg
2

And with temporary axis display?

2 Likes
3

Hello,

I've already had to do this on imported parts with deadbodies, my technique:

Create two sketches on the beginning and end planes of your cone to position a point in the middle of the elipse that your cone creates on the face.
Then you can create an axis with these two sketch points.

5 Likes
4

Thank you men,

I don't understand what you mean Michael,

Sbadenis doesn't work either

5

It's okay I found it.

I created a sketch on each side, I inserted a point and I was able to draw my axis

2 Likes
6

How did you create this cone?

@+

7

uh how do I choose the best answer?

1 Like
8

Sketch on each side, with a dot in each sketch, that's what I tried to tell you just before =)

4 Likes
9

you do as you want but it seems to me that Michael DELACOTE 

Deserves the bonus

@+ ;-)

5 Likes
10

You did exactly what Michaël DELACOTE had proposed to you... So it would be logical for it to be him.

1 Like
11

And yet I hadn't understood everything.

12

And yet I hadn't understood everything.

Thank you to him, and to the others of course.

1 Like