Ebony ring for my daughter

Out of category
1

Hi all
I would like to make this ebony ring for my daughter with SW and my CNC.
But.... I just spent the afternoon to come up with something clean...
Without success, I always end up in a dead end from which I can't get out.
Of course, I don't have the right method or approach!
Can you guide me?
Bernard

bague ebene 01
ebony ring 011493×1032 86.5 KB

Attached is the photo for the general shape (not for the inlays)
bague ebene et diam
ebony ring and diam613×604 127 KB

2

Good evening

If it's the ring that is causing you problems, two smoothed surfaces, a little seam, and you're done. If it's the stones, see a jeweler...
image

2017 SW gasket model.
Kind regards.

RingEbene.SLDPRT (218.1 KB)

6 Likes
3

Hello, Thank you very much!!
I had gone on ridiculous symmetries experiments...
I learned new possibilities again!
Thank you again.
Kind regards.
Bernard