Hello, How to turn an image into a sketch for extrude. Is this possible? Thank you

3D Design Volume Model
2

yes it's quite possible

See this tutorial

http://www.lynkoa.com/contenu/tuto-cr%C3%A9ation-dun-model-laide-dune-image

@+ ;-)

4 Likes
3

Test this vectorization site, if your image is sharp it works pretty well

http://www.vectorization.org/

 

1 Like
4

without the need to use a third-party "online" tool (beware of data confidentiality)

there is the "SW - Autotrace add-on" which could correspond:

http://help.solidworks.com/2016/french/SolidWorks/sldworks/r_Sketch_Picture_PropertyManager_Page_2.htm?id=ad107f42a9d6493dbb9ab8acd72c4b94#Pg0&ProductType=&ProductName=

 

4 Likes
5

Hello, yes I do it with Autotrace as well. Be careful, however, the better the quality of the image, the better it works!! :)

but its rough up the work well.

 

Cdt

3 Likes