Hello, I'm trying to remodel a statue so that it articulates, but I can't seem to make the shape of its foot. I noticed during the bump that the rendering was hollow, I think that's where the error comes from, the screenshots will tell you more.
Thanks in advance,
Adrian
Hello
I am 2016; Can you share your file so we can take a look at it?
Here is the file, you will notice that there are a lot of useless sketches (I must say that I am a beginner).
Dsl I can't open because you did it on a version higher than 2016, Solidworks doesn't allow opening a file with a version older than the design version of the part
Hello Adrian
Try the boundary surface tool in insert/surface
Below are screenshots and attached the modified file (not obvious that you can open it, you are in education license 2014 and I am in 2020 pro)
Sorry ac cobra and thank you anyway.
It worked qlamy thank you very much!! x)