Hello

Out of category
1

In an assembly when I put a part in transparency and then I try to turn the assembly there is a trail on the screen (photo below).

We spent last week in SolidWorks 2018. 

Thank you in advance for your help!



capture.jpg
2

Hello

I think it's a graphics card problem.

Have you checked its compatibility?

http://www.solidworks.fr/sw/support/videocardtesting.html

3 Likes
3

Launch Solidworks rx and update the graphics card

3 Likes
4

It's weird because the transition from Pre-2017 to 2018 is done without any problem. The graphics card is not used more in 2017 than in 2018.

It would surely be different with the 2019 version which uses the graphics card much more. For the record , this is the main effort that has been made on the code to make the rotations, zoom, ETC. more fluid.

So it's quite likely that with the 2019 version some board issues may appear for large assemblies.

5

I'm also thinking of a problem with the update of the drivers of your video card.

it has already happened to me to have to reinstall the drivers after the SW update