Hello everyone,
I have a little problem with a drawing.
I draw a curved tube. And I'd like to insert a break in it.
My problem is that where I would like to insert my break, the tube is at an angle and I can only make horizontal or vertical breaks.
As a result, when my break is made, the 2 ends of the tube do not seem to be aligned (see attachment)
Do you have a solution, a solution to remedy this?
Thank you in advance.
Fred
Hello
There is no solution for this problem (unless you fall into hacking). This is a subject that has already been mentioned several times, especially here: http://www.lynkoa.com/forum/cao/cassure-sur-vue-isometrique
The hack would be to make 2 views, and crop each one on one side, then position them so that it looks like it's just one.
+1 Benoit!
to tinker, no way to do it automatically...
Mouep, we're going to do it differently then.
Thank you for your answers.