Hello
I'm currently in the process of setting up the elements to be able to do costing with the solidworks costing module. For sheet metal no problem, on the other hand for mechanically welded elements of the profile type (Square tubes, UPN ect), the software cannot find the length of the part (see attached photo). Do you have any idea where this could come from? I checked the custom properties and the lengths are fine.
Thanks in advance,
Kind regards
Hello
Have you found the solution to this problem? because I have the same one and I can't find the solution...
Thank you
Hello BE-Celine,
This question is more than 3 years old, so I think you won't have any answer on this subject... @+.
AR.
no big deal I found the bug on my own 
, even if it doesn't suit me either...
the name of the property must be put in " English " in the table of the list of welded parts, i.e. " LENGTH " and it takes into account the length for the calculation of the raw material.
so it's a hassle in my case, because I'm not going to have fun changing the descriptions of my tables
Magnificent once again, thank you Dassault!
Merci BE_Celine,
@+.
ON.
Thanks for the info except that it's not me who is the one who is at the instigation of the problem so I don't have this button it's @ floriandesousa_1 who should have it...
A+
Oops, sorry, I read a little too diagonally...
