How to create an offset tapered floor in sheet metal with solidworks

Out of category
1

How to create an offset conical bottom in sheet metal in order to have a press?

Thank you in advance for your answers


fond_conique_deporte.jpg
1 Like
2

Two parallel planes must be created.

 

Draw the two profiles on each plane, then connect the whole with the transition fold function.

3 Likes
3

Something like that?

 

But as a deportee. Is that right?


tronc.png
2 Likes
4

Thank you very much Bart it works tiptop!

1 Like
5

Derien ;)

 

I like it when everything is going well!

Pleasure =)

 

 

2 Likes
6

On the other hand, it is necessary to create two half cones, see attached view.


demi-cone.jpg
1 Like
7

No, you need to create your two open profiles.

 

See attached.

 


tronc2.png
1 Like
8

It's okay? =)

2 Likes
9

ok it's like for a ferrule

1 Like