Hello, Is it for a simple representation or a 3D knurling?
Hello
See here: www.lynkoa.com/forum/solidworks/moletage-sur-3d-et-mise-en-plan
and here: http://www.lynkoa.com/forum/3d/creer-un-moletage-en-dur-sur-une-surface-lissee
and again here: http://www.lynkoa.com/forum/3d/moletage
Either with a "pattern" type appearance, or by modeling them.
I'll look more at the first solution (see pj)
motif.png
in surface condition via an appearance it is much simpler and less heavy
Thanks the knurling is done now.
Benoit
It is important to determine the best answer. This allows people who will have the same problem to know the solution. As well as to award the member in question 40 points.
Thank you.
I did it, and it was yours.
I did it, and it was yours.
I did it, and it was yours.
It's a bug in the forum, the best answer doesn't appear.
Clémentine and her team take care of it;)
It's a bug in the forum, the best answer doesn't appear.
Clémentine and her team take care of it;)