Hi all
Stupid question, but how do you make an edge fall on a sheet metal rolled with solidworks?
Thank you for your help
fitting.sldprt
Hi all
Stupid question, but how do you make an edge fall on a sheet metal rolled with solidworks?
Thank you for your help
Good evening
Here is a sheet metal piece with a fallen edge with the edge falling outwards but it also works inwards.
PS: I didn't manage to open the room; You did it in 2016. In order for everyone to enjoy and understand, it would have been necessary to put an image of what you want.
Good evening Manu67,
Thank you for the answer it's exactly what I was looking for
but I was doing it very badly
Thank you again and have a good evening
You're welcome; We're here to help each other. Good evening to you too
Good answer @mpanu! thank you for your good tutorials!!