How do I measure the smallest side of my geometry?

Out of category
1

Hello everyone;  

 

I am trying to measure (without having chosen it by myself) the area of the smallest surface in my geometry.

Do you have an idea please? (I use CATIA)

Thanks in advance 

2

Hello apart from Q-Checker (it controls the number of small areas in a model) but you will have to evaluate the benefit / costs of this solution (for a single Ctrl I have my doubts).

I have very few CATIA workshops but depending on the ones you have I would look for the proposed analyses?

3

Hello Franck;

 

Thank you for your answer. I found the solution, it can exist on another software (Ansys Design Modeler), you select the edge, its length is displayed at the bottom, Ansys Meshing automatically measures the length of the smallest edge.

 

Kind regards

1 Like