Hello everyone,
I have a plan to make and I would like to put all my configs in the same welded mechanics
except that there is a column (area) that I can't update on my own
If you have an idea
Attached is a jpg to understand my problem
For my first line which corresponds to my config 1 no problems but it's in my config 2 where my length changes that I can't put my surface automatically
thank you in advance
Hello, how is this property obtained?
I guess this surface is obtained with the welded part list and sheet metal sidewall surface.
How is the multi-body part or a body with configurations on the long and wide of the sheet metal side.
Otherwise in your table (MEP) you have the length of the sheet but not the width so impossible to check the veracity or not of the calculation.
Send us your room tree to better understand for everyone and why not room + MEP if possible (depending on SW version)
For my part (SW2020) on a multi-body part no problems the surface is good (hence my question about the configs)
Attached is my file
I don't want to show my width in my painting, the area and the length are enough for me
and since the surface is calculated from the sheet metal flank formula, normally no problem it is done automatically
What I would like to do is to make all my lines of welded mechanics of each config appear in a single table rather than saving a new plan each time
On my part sent, I have 12 configs, so I would need 12 lines in my welded mechanic panel
In this case rather than displaying the list of welded parts, why not insert the part family table (click on the part, insert, Table, Part family) by filling in the elements you want in this part family.
Add the width to be masked next, the surface (formula length x width), add your Hérackles flock...
Because in your welded parts list table it only displays the bodies used in the displayed config (not possible for me to display in this table all the configs)
EDIT: With the image it's better
Because in your welded parts list table it only displays the bodies used in the displayed config (not possible for me to display in this table all the configs)
That's what I thought, but I hoped there was a solution!
yes I thought about the family of parts but I don't know I don't like it, but not too much choice I think