How to Tolerance a Depth in the Drawing

3D Design Volume Model
1

Hello

 

I'm on Solidworks 2016.

I would have a tolerance of 0/-0.01 to notify on my plan for a depth rating.

Except that when I apply the tolerance it is added to the Ø of the hole and not to its depth.

I did specify in my document template the tolerance I wanted on the depth of the hole, but it would not reappear on the drawing when I use symbol for drilling, and I can no longer do it manually.

I would like to do this Ø5 (<HOLE-DEPTH> logo) 0/-0.1 but with the symbols

 

Thank you

 

 


profondeur.jpg
2

Hello

When you apply this tolerance, you click on the 0.6 dimension to add it ????

1 Like
3

How did you make the hole with its countersinking??? Can you attach your piece???

1 Like
4

Hello

Otherwise you can put the tolerance on the piercing symbol on the drawing.

Cyrille

4 Likes
5

Hello

For my part, I would have seen simply a cross-sectional view with a sufficient scale to put the dimensions and tolerances and at the same time show that the countersink is flat-bottomed.....

Kind regards

3 Likes
6

Cyrille. CM is right to use "the right tapping dimension function"

after, yes it can be completed by a cross-sectional view, or other...

When using the Drilling Wizard in 3D, you must use its associated dimension "Symbol for Drilling". Because it brings all the information about the drilling down to automatic, as well as the quantities.

(yes the disadvantage of Solidworks which has not yet evolved on this point, is the presentation in an "in the axis" view)

What for? to simply no longer do any "semi-manual or forced scoring" in MEPs.

It's just a good habit to get into, but I know that the bad habit is very common unfortunately.

 

7

Thank you Cyrille.CM I think I'm finally going to do it like this.

But it's still weird that it's not possible to upload the 3D information in the MEP.

 

Thank you all!