Hello, I think I made a mistake even when checking them, I still can't visualize the lines and points
on the 3D.
Hello, I think I made a mistake even when checking them, I still can't visualize the lines and points
on the 3D.
Hello
You probably have a selection filter enabled! F5 then deactivate all filters:
http://help.solidworks.com/2012/French/SolidWorks/sldworks/r_Selection_Filter.htm
If you are talking about the X, Y and Z projection lines, you have to check the 3rd option "Show XYZ measurements.
See this link
http://help.solidworks.com/2013/french/SolidWorks/sldworks/HIDD_MEASURE.htm
http://help.solidworks.com/2013/french/SolidWorks/sldworks/t_dual_dims_measure_tool.htm
http://help.solidworks.com/2013/french/SolidWorks/sldworks/t_using_the_measure_tool.htm
everything is explained
@+ ;-))
Hello, the problem is solved (restoration)
Yes, otherwise it's sure that a restore of the settings solves a lot of things, but you still have to have saved all your parameters just after the configuration of the keyboard, mouse, paths etc...