Indeed, it is coherent.
Careful;
For holes made with the drilling wizard, it is imperative to use the " specific to this configuration " function in the wizard command and not directly on the dimension (otherwise it very often crashes when generating the Excel table)...
=> If it's a smooth hole, it's the only case where I recommend a simple material removal (much more " stable " to configure) rather than going through the drilling wizard...
1 Like
Good morning, sir
I have renamed the rating 7 as shown in the table and it is resolved !!
it takes into account the diameters and length of the balls etc...
On the other hand I still don't know how to link an extrusion / removal or any function with an array like the part I was asked to modify. ^^' I created a separate room to test but it failed
Thank you all
Look at the tutorials on YT or other, there are plenty of family parts and it will guide you
1 Like