Hi all!
Back on the forum for a fairly basic question... It's been a long time since I have practiced this procedure and therefore a little memory lapse... I hope you can refresh my memory ^^. Let me explain:
I have a part that I insert into an assembly.
This piece is found in several places in this assembly
It does not have the same size depending on its location
I would like to control its length according to the length of the part of the assembly on which it is placed. (Are you following me? ^^)
So I would like to insert this part several times while being able to drive it via different hills
I tried the configurations, the families of parts but without success (memory gap)
If I summarize, we would have to basically link part configurations to equations of assembly.
Do you have an idea?
Thank you;)
capture.jpg