Bolt connector in solidworks simulation

Simulation Generality
1

Hello

I drew a courtyard in metal frame, in the simulation tab, I put all the necessary contacts, I added my anchor bolts (with virtual wall, characteristic of the bolt), my connecting bolts between the different bodies that make up the framework.

When I do the simulation with solidworks, no error, everything calculates well, but when I do an axis/bolt check, I end up with only 2 anchor bolts that are ok (while I have 60), and 0 bolts that deserve attention (while I have about 200 link bolts).

In detail I find all my bolts, including the two which are ok (so in green), none in red, but everything else and in grey.

Is there an explanation?

Thank you for your enlightenment.

 


imprim_ecran.docx
2

Hi all

The bolts which were in grey, came from my connector library, I redid a simulation by redefining the connectors one by one and it works.

So I deleted my connector library, but I still don't know why, some worked and the rest didn't

Thank you for your help and good luck