Jlamb
September 20, 2019, 7:59am
1
Hello everyone,
I need to create a particular Cylinder/surface constraint but I can't find the trick ....
I'll let you take a look at the attached video (in the archive).
Be careful, it's not that easy to do!
Good luck to those who try.
Julian
lynkoa_bz.rar
There is a cam constraint that should be fine.
2 Likes
Jlamb
September 20, 2019, 9:04am
3
with a "curved" and not flat cam raceway, I don't think it works :/
Hello and a "standard motion" movement study doesn't do the trick?
lynkoa_assemblage.mp4
Jlamb
September 23, 2019, 6:44am
5
Hello, Thank you for your answer but no, Motion study is not the solution.
Hello
You can always interpose a sphere, however the contact can only be done on the outer edge (the construction of the contact surface of the cylinder does not allow you to place a tangency constraint except for the low and high positions).
lynkoa_assemblage-1.mp4
Jlamb
September 23, 2019, 2:07pm
7
Great idea!
I'll try this as soon as possible, thank you