Hybrid body in catia v5

Hello

I want to know if there is a solution to transform a hybrid body to a normal body in Catia V5

Hello
Not to my knowledge.
To make up for it, there is no universal method either, it depends mainly on the type of body (part, surface), the interweaving of the surface and volume elements in the same body, the parent-child links.
I have two ways of working:

  1. I'm looking to copy/paste the elements of the hybrid body into a new normal body.
    (it can work if the graph is not too large and no volume surface mix).

  2. I place myself in a new CATPart in Mosaic window mode (I display both) and I rebuild by recovering what I can from the hybrid model. In particular the sketches, the plans, everything that CATIA will allow me to copy/paste, the rest I do again as the reconstruction progresses.
    If the CATPart Hybrid is used for a drawing or in an assembly, I delete all the geometry and then reimport the one I redid (optimized copy) so that I keep the ID of the file and therefore my links. Of course, everything that relied on hybrid geometry must be redirected (constraints, dimensions, etc.)

Hello IKRAM. EARL
I was a very small user of catia "V4".
But look at this link I think it answers your question => What is a "normal" and "hybrid" body in CATIA? - #2 by franck.ceroux

Frank.ceroux's answer on this subject.

Good luck.
Have a nice day.
AR.