Hello everyone, on most simulations I am faced with a problem of nodes that have large stress values and which suddenly block me from releasing a report with a work rate for example
How do I know the node doesn't reflect the analysis? simply because the constraint is not diffused from this node but local and the nodes around it have much lower stresses
Does anyone have an idea to clean these unsightly knots
thank you
Have a good day
Hello and welcome;
We need a little more context...
=> Which version of Solidworks?
=> What type of simulation (beam / volume...)?
=> Which solver?
=> What time is it?
…
And some screenshots would be welcome...
2 Likes
Hello,
It happens under simulation that some nodes ' snag' when they shouldn't.
The only solution I found is the remeshing of the area (often by adding a different size so smaller) / recalculation.
If your calculation / study area does not concern this area, you just have to ignore it (if the blockages related to these nodes do not block your movements too much for the rest of the calculation to be valid, otherwise you have to remesh)
thank you I'll try this
Have a good day