Hi all
There you go, I would like to know if you can have a display of the quote without ".00" on the nominal dimensions when you are configured in 2 digits after the decimal point by default.
In fact I'm a little tired of having to take over the accuracy of my nominal dimensions one by one when drawing and don't want to leave the two digits equal to zero either.
In short, a bit like in CATIA V5 in short.
Thank you in advance.
Hello
I know of only one solution, and that is the general rating parameter.
but it's for all odds.
Jerome
Hello flo44
for the "useless" Zeros to be removed automatically there is an option called "Zero to the right" with the setting to smart the "useless" Zeros disappear.
Options / Document Property / -W Dimensions at the bottom right in the "Zeros" box
Edit: Actually it's just a little lower on the image posted by @ Todesco
great thank you. This is exactly what I was looking for.
Thank you very much.
Re
The idea is good but the message I get has less
Jerome
curious, I'm on SW 2018 sp5 and I made the modification without encountering any problem.
I did a test and it works very well