Dimensioning lights in the drilling wizard

3D Design Volume Model
1

Hi everyone

I start SW15 and try to make linear lights via the wizard for drilling. And there's something I don't like: the dimension seems to be necessarily on the outside for the length, and not on center. So if I change the width of my groove, I also need to change its length to keep my rib functional! :-/

I don't think it's great at all. Is there a way to change this?

Attached, an image of the subject and the green rating of what I would like.

Thank you in advance.


screenshot2454.jpg
2

Check this box Benoit ;)

Logically it's good

 


case.png
2 Likes
3

Sorry, it's more here =)

 

 


rainure.png
2 Likes
4

Hello

A priori it's not possible, there is an SPR 862375 in "Open" status:

Ability to define 'Slot length' for slot in hole wizard with center to center distance instead of overall length, i.e. end to end of arc.

 

2 Likes
5

Wouldn't that be a close to it rather @Bart? :D

3 Likes
6

@Bart, the first option is already checked correctly, and the second is when you draw a light for material removal. Now I'm trying to use the wizard for drilling.

@.PL, that's obviously it. Well, I'll use it better than from SW 17!! TOO BAD

2 Likes