Hello, We just switched to the Solidworks 2023 SP 4.0 version and my truncated diameter or radius dimensions jump every time I make a recording.
Has anyone ever had the problem (my colleagues have the same problem as me)? A solution?
Thank you for your feedback
1 Like
Hello.
Just a question... Why did you take the SP4.0 and not the SP5.0? You would be at the maximum level of solidworks patches
5 Likes
Oh well I didn't know there was an SP5.0. I'll see with my IT department to do the upgrade. Thank you
Hoping that this solves the problem.
1 Like
When in doubt, it doesn't eat bread 
On the other hand, I was looking for where we could find what was fixed by the Service Pack without finding. If anyone has an address?
1 Like