Hello everyone
Does anyone know what the layer adjustment is for in the document/dimension/layer option?
You might think that the chosen layer becomes the default destination for the dimensions created, but this is not the case.
The dimensions are arranged in the layer used to create them. 
CDLT
And yet, that's right.
Once the layer bar is displayed, select "According to the standard", the dimensions and annotations will automatically go to the right layers
3 Likes
Good answer for Yves.T!
great thank you to you;)
Thank you for passing Yves.T's answer as a good answer even if the post is short;)
Although appreciated (the thanks) it's not the best answer to your problem;)
2 Likes
Hello
@FUZ3D: don't you like my message:) I couldn't make it longer between two phone calls:) At the same time, there wasn't much else to say. And I must admit that I'm not a great literary person... The fault of putting annotations on plans surely or because I'm a bit rough around the edges...
@p.chailloux: The best answer is not to look pretty, it's so that other people who have the same question as you can find an answer quickly.
1 Like