Hello
How to drag a section of the 3D previously saved in an annotation view into a drawing.
The cross-sectional view appears in the view palette on the right but I can't drag it into the MEP.
We are with solidworks 2015 SP03
Thank you in advance
1 Like
Hi my good Fifi,
The same topic here: http://www.lynkoa.com/forum/3d/inserer-une-vue-iso-en-coupe-dans-une-mise-en-plan
Basically, the solution you're hoping for doesn't work, but a fairly simple alternative is possible.
2 Likes
PK A simple cut in the MEP is not enough?
You also have to put the view that defines the section
1 Like
and if the view that defines the section is outside the frame of the plane
@Samuel, did you see the video in the attached discussion?
https://www.youtube.com/watch?feature=player_embedded&v=5pGSxHDByZs
1 Like
Hello, yes there is a solution,
Your mistake is that you want to put your cut first, place the view you used to make your cuts (for example the front view) and then place your cuts.
I hope I have been clear !!
May the force be with you.
1 Like
Hello
Thank you for your contribution, indeed you have to load a 1st view (front) and then the cut and it works!
Re
And well no it doesn't work, I can put the view in the mep but this one is not in section!
1 Like
Hello
Normally you should find all the views in the view palette with their name.
The view used for the section as well as the section view (in my example the top view and the section view a-a). You can see that on my top view there is the cut line.
Then a simple slide and you're done.
Kind regards.
coupe__mep.jpg
1 Like
ok it works! I tried again with another part and it's good!
Thank you