Hello
SolidWorks2016 Crash when opening the .sldrw plans since this morning on my PC.
My IT department did an update of the drivers and Windows 10 last night on my PC.
I can't perform a performance analysis via SolidWorks Rx because SW crashes and restarts during the drawing test.
How do I see if my PC is properly configured?
Do I need to change any display properties in SW?
Thank you
Hello
On the off chance that you don't have a second SLDWORKS.exe process running in the Windows Task Manager (detail tab).
Kind regards
Good evening
look at the solution proposed by Obiwan (who is probably sulking us too busy since the visiativ connect day ;-) ;-) ) at the bottom of the first page
https://www.lynkoa.com/forum/mise-en-plan/crash-%C3%A0-louverture
Cdlt
Already do a test by going back to the situation before the Windows update, update which seems quite substantial.
To go back:
- either there is a restore point and then you have to test by installing the updates one by one, testing SW each time;
- either uninstall the updates one by one and test Sw.