Hello
Do we have the possibility to create bubbles to number the dimensions on a plan automatically?
This would allow us to have, on the PVQs, the same numbering regardless of the evolution of the parts.
Our problem right now is that if we want to put bubbles on each side, we have to do it manually.
As a major waste of time, we would like to know if an automatic system exists.
Knowing that we are moving to the Creo software in mid-2014, is there any interest in making an investment now?
Thank you.
Hello
Too bad you're not on SolidWorks! Indeed, we have developed this tool in our myCADtools suite, it is called "ToleranceTable" which automatically creates a table numbering the dimensions of the drawing including the geometric tolerances.
But this must probably exist under ProE!
Kind regards
2 Likes
sb
September 18, 2013, 8:30pm
3
So now, I'm drying.
If you retrieve or modify the id of the dimension, it takes even longer than the bubble.
Does a repeat region parameter match the dimensions? I've never seen it.
I would advise you to make a macro keyboard to save time and avoid many clicks.
Kind regards