Hello
A very small problem that I think you will solve in no time (making me feel even worse:D)
On this piece:
I can't create the 5° draft that appears on the cross-sectional view. I think I must not be doing it right...
Thank you for your help!
If it's in SolidWorks, the easiest way is to put the draft directly into the extrusion function.
1 Like
Hello
The draft is to be created with the chamfer function.
You have to enter the value of the angle and determine the necessary distance from the edge of the workpiece,
and only after using the leave function for the R6.
Or use a material removal sketch (with the desired shape) on your middle plane.
4 Likes
it's on a solidwoks part
and if it's good like on your F-F cut plan
it's not easy to see even with a zoom
It's up to you to create a parallel shot to your cut
Dee create a sketch corresponding to this bias (this shape)
you rate everything to have your black sketch
and elevation of matter if your plane is axis you remove in 2 directions
that's if I understood correctly
@+
1 Like
A line is missing from the front view.
But I'd do like Azrod, i.e. a chamfer and then the R6 radius
2 Likes
Indeed there is a line missing, I admit that the 2D plan does not come from me;)
I finally went through a very simple material removal function, I had thought that the body was going all around the room.
Thank you for your answers!
1 Like