Creating / Modifying an SLDBLK Title

Out of category
1

Hi all

I'm looking to create a "typical" title block that will allow me to easily insert it into my new drawing templates.

I have an old file in SLDBLK format that would correspond a little bit to my expectations,
Except that a property is not good.

I am not the one who made this file and I don't know how to make it.

Do you have any leads to give me?
On the possibility of modifying properties in a title block (in sldblk format)
Or on creation in order to start again on a good basis.

2

Hello

Normally, your cartridge should be in your background plan templates, but to modify it, just double click on the property and replace it, then right-click on the block, then add to the library and you're done.

2 Likes
3

Or else you click on the block and you have it edited and after modifying it you close it and right-click on it and save the block. 

4

Ah, it was the recording of the block that I was missing.

Each time Solid refuses to close the block for identical names

Thank you!