Hello
After copying a standard to "Drilling Assistance" in the Toolbox configurator, we would like to add a "Type" named "Cylindrical Pin" to the "Drilling Type" "Chambering".
The idea is to create cylindrical pin hole drill sizes in a family form.
Thank you all,
Hello;
In the following discussion, I left a little tutorial that should help you.
Kind regards.
Hello
Thank you for your answer.
In reality, what we want to add or change is the " Type ":
By going through the Toolbox configurator, we can't add anything other than a standard.
Thank you
Hello I don't think it's possible, the Solidworks " logic " seems to make the Type depend on the Type of drillings...
Should we look at the " SWBrowser.mdb " registries of the drilling wizard?? To dig into but for the moment I don't have any ideas...
Kind regards.
Hello
To follow up on what @Maclane said, the easiest way is probably to add a standard with your dimensions under the type "smooth hole" (since in the end the geometry is that of a smooth hole, only the dimensions/tolerances will change)
