Creates cn file of a UPN 240 on solidworks 2012

3D Design
1

  hello I have stringers in upn 240 with a lot of drilling to do  on it .is I would like to create numerical control files to send them to a drilling bench this and it achievable version 2012 standard   

2

Hello

It is possible but you need to know the type of file that is used by the machine.
Typically, these machines use DXF files (to be confirmed by your machinist).
If it's DXF then just do "save as" ===> Copy the file ==> select the DXF extension ==> validate. After the manipulation you still have the original file plus the DXF file.
The 2012 version can handle DXFs without any problems.

On the other hand, if you have holes on several sides of the UPN it's more complicated (see with the machinist if the DXF file should not be generated per side, but it depends on the machines
Our colleagues will tell you more about that.

Kind regards

3 Likes