Create a square bowl with a high part that will end in a circle

3D Design
1

Hello to you.

I'm in the process of designing a square tank, with a "complex" part on its upper part and naturally I can't do it. That's why I'm calling on you.

I have attached the file with all the details.

Remaining available if any data were to be missing.


cuve.sldprt
2

Post images instead

have not all the same SW version

@+

3 Likes
3

Me again. No need to look anymore, I found it against all odds..!

The tutorials on the net helped me a lot, I admit it.

Happy confinement to all!

 

1 Like
4

Hello

To do this kind of transformation, here's what I do to make it always work:

  • Same number of straight parts and radius in the 2 sketches (1 sketch for the base and another for the upper part (inclined if necessary)
  • The corresponding straight parts in the 2 sketches should be // (see attached image)
  • Then in the square part I put radius the smallest acceptable (depending on the bending radius
  • In the circle part I do the opposite on the right side of 1 or 2mm only (here 20mm to see that the line is // to the other)
  • Of course open the 2 sketches on 0.1mm face to face
  • Choosing the sheet metal and transition bend module

If you respect this should be able to make your transformation without any worries.

https://i.imgur.com/Z3UuK4a.png

 

3 Likes