Hello everyone, every time Creo starts, I have to check the boxes of the floating modules to use them, unlike my old version of ProE (WF4), do you know if there is a configuration option to have the floating modules directly at startup.
Kind regards
see this link he talks about it
http://support.ptc.com/WCMS/files/123932/fr/install.pdf
@+ ;-))
1 Like
Hello
A solution can probably be found here:
http://communities.ptc.com/thread/40806
1 Like
Create a config file when you have your floating modules, then make sure that CREO goes to get it when you open it.
I did it like this to set up my length units and I think it's a bit the same principle for modules.
Hello
To answer your question, it's possible.
With us, it was the opposite, we started without a choice and the last one was left without the floating modules. Now, we choose at startup.
However, I don't know exactly where it is, maybe in the license server on each workstation.
It works!
Indeed, you have to go back to the installer and reconfigure the licenses.
Thank you very much!
1 Like