Hi all
Would someone have the patience to explain to me how to make a symmetrical 90° 400x400/800 panties on catia.
I managed to do it without any problem for a panty in 2 diameter 400 and the outlet in 400. But I get stuck when I try to do it in 2 input 400 and output in 800.
Thank you in advance
gt22
November 17, 2016, 7:47am
2
see below the procedure done under SW
I went through a smoothing of the 2 sections to create the elbow with 2 sections
cut this bend by its axis with a large diameter
and makes a symmetry
after hull function
and uncorks the extremities
see attached file SW 2012
I know that your request was under CATIA
but I only have SW on hand at the moment
But the approach is more or less the same
culotte_symetrique_800-400.sldprt
1 Like
Hello
You can use the "Multi-section surface" GSD or "Solid multi-section" PartDesign functions.
In the video if attached, I create the direction and then two lines for the closing points.
I created circles 800 and 400 (Center and radius) I should have selected Center and points .
cullote-400-400-800.mp4
3 Likes
Great, thanks both of you for your help!!