Can CuttingOptimization handle a bar stock of the same type but of different lengths?

Out of category
1

In order to improve the use of bar scraps, can we enter different bar lengths in CuttingOptinmization so that it can draw as well as possible from the stock?

Example: in stock 2 bars 40x40x2 lg 6m, 1 bar 40x40x2 lg 2.5m, 6 bars 40x40x2 lg 3.3m instead of X bars of Xm

2

If I'm not mistaken, just check fall and then put your values there as on the attached image.

2 Likes
3

This is also what I understand when reading the help:

1 Like
4

Thank you all.

Indeed, I didn't see it that way. I'm going to test to see what the order of priority of use is.

Have a nice weekend.

5

Hello

I tested it, it works well.

However, in the automatically generated report, the scraps used are not separated from the "new" bars. They are put first in the list but there is no marker. Maybe an area of improvement for developers... We would just have to add for each bar used its length.

Thank you again for your help.

6

Hello

Please name the answer that helped you. This will close your question and reward the person who provided the answer.

Kind regards

1 Like