Hello.
I need to de-emboss a handle and then put a non-slip surface. However, I can only do it with the
winding that does the work only on the cylindrical part. I would like this to apply to the flat part as well.
Is this possible?
Thank you
Maybe try to go through "separation line" and then "offset surface". You will obviously have to go through surface and then come back to volume.
Do you have a small example? A bit complicated for me.
Thank you
Hello Ahmed. And thank you.
I've been trying in all directions for an hour, but my result is not at all the same.
I always get the same result. Note: Embossing only on the sides
flat, while the curved surface is also selected.
I don't understand anything anymore. However, it is the result you obtained that interests me.
Happy holidays.
Given the price of a Solidworks, I'll continue like this. :(