Drawing

Out of category
1

Hello I'm not very good at drawing my I broke a crankcase at home will it be possible that anyone  model iton solidworks thanks to the plan so attached  

Thank you for Avence

 


snapchat-437642430.jpg
2

I tell you the other plan here


snapchat-1398259940.jpg
3

here is the last one


snapchat-1881395749.jpg
4

It's not particularly complicated.
Are you the ones who are going to make it?

2 Likes
5

In French either ;-)

We want to help you draw it but not do it for you.

Too often, at the end of the year, the trainees arrive and ask for the work to be done for them. But I personally have other things to do.

Start drawing, expose where you get stuck if you block and then we will offer you solutions.

This is the one and only way in my opinion to progress.

To do and to undo is to work!

Hint: I would start with the sheet metal module

2 Likes
6

Practice makes perfect!

7

Start drawing your sketch (your foreground) and extrude the sketch of the desired value .

Then, by searching a little, you will find a very practical tool that can allow you to hollow out your solid ;) 

You will only have your engraving to do.

Courage, there is nothing complicated, the hardest thing is to get started.