Hello
In solidworks, following the insertion of a view on a drawing sheet, when you select "unfolded state" in order to obtain the development of the sheet metal part, the software systematically switches to "custom scale", although the state view initially in "sheet scale".
As a result, scale errors can occur when exporting to dxf, since the scale of the view does not systematically correspond to the scale of the sheet, which can be a problem for the use of dxf in laser cutting for example.
It is therefore necessary to systematically check that the view is indeed in "leaf scale".
Isn't there a way to change the behavior of the software so that it doesn't change the scale settings when switching from a classic view to an unfolded view?
Thank you in advance for your answers.