Hello, I'm new to solidworks.
When I wanted to add the thickness in the 3 surfaces, there is an angle between the 2. I cannot use the leave to be corrected.
I tried combining 2 surfaces, but it wasn't possible.
Do I have to do the other thing except to add thickness?
Thank you.
Susan
epaissir-baignoire.png
1 Like
gt22
2
You probably would have had to sew your surfaces to have only one surface
before thickening
radiate and thicken them afterwards
@+
1 Like
Hello
To make this part I would have made my part like you but full via extrusions and then would have just applied a shell function....
2 Likes