Hello
I designed a helicopter canopy in surface.
I did it shot by shot spaced 10mm apart.
On the other hand, I have to remove material to finalize the shape but I haven't found this function.
So I transformed into a solid and there the function exists but doesn't work.
I don't know how to do it anymore and you?
I attach the file to you in surface, the last sketch, on the right view, is the shape of the material to be removed
diiity
First of all, you have to sew each surface
after thickening
After taking your sketch 57 Extrusion Material Elevation
That's it
Personally, I would also have made guide curves to regularize the profiles
among other things the C 10 profile is making a face
@+
PS:
Avoid validating yourself best answer when this is not the case
to see the shape defects
Take Zebra Tool in Evaluate tab
It allows you to see the breaks in the profile
See attached image
@+ ;-)
For the best answer it was to close the subject, sorry
I managed to correct the C10 but the tip is not won
Create planes perpendicular to profiles
This will allow splines to be created that will be constrained with each profile that will allow
Harmonize curves
@+
compared to the right-hand view and offset by the width of the profile
I succeeded in my own way, maybe not the right one but I'll be fine.
The tip is not great but with thermoforming and with paint it will pass.
Is it possible to fill the inside?
No problem
post your part that I'm testing and give you the procedure to follow
@+