Hi all
I have a problem every time I save a shot made on Creo in PDF. My annotations shift on the PDF, I put an image to illustrate my problem. On simple plans it's not a problem, but when there are a lot of annotations, it's more complicated...
I don't know if on Solidworks it does it too.
Is there a parameter to change or do I have to get used to the idea?
Thomas
Hello Tomalan,
I also sometimes have this problem with SW. But more than the annotations it is sometimes pieces of views that are missing...
If anyone has a solution, I'm interested too.
Cdt
Eric
Hello, wouldn't it be a font problem?
Does it do it on the sides that are to the right of the arrow?
No, I noticed that it doesn't do it when the note is on the other side.
I'm going to look by changing the font.
Thank you
Ok it must be that so, try to ally your sides to the right or left before exporting it should solve the problem.
Slt Thomas,
Do you use PDF Creator? to create your .pdf
@frédéric: No, to create my PDF I use the "publish" function integrated into Creo.
@Tonton: changing the font works, but it all depends on the font chosen.
Thank you for your help