Hello
I am having a problem rebuilding a pipe on a large assembly and the error disappears when I edit the pipe concerned but the rebuild light remains displayed.
Does anyone have an idea where the problem can come from?
Hello remi.bression,
Have you updated your graphics card, it could come from there.
Keep us informed.
@+.
AR.
Hello;
Check if any external references (Constraints) exist between your tube and your assembly.
If so, lock them, and re-check your assembly.
The same goes for possible equations, constraints, configurations...
If this persists, make a save-copy-under of your pipe and replace your original component with the latter... If the same errors are present, further investigation will be required.
Subsidiary questions, is your tube extruded on a 3D sketch? Is it Mecanasoudé?
Kind regards.
1 Like