Flow study with rotation in solidworks

Simulation Generality
1

Hello, I've been fighting with solidworks for a week to do  a flow study on an air turbine . Am I a beginner:)

That's why I'm looking for someone who could see if he has the solution to my problem.

My problem:

I have a simple turbine (casing, propeller, and 2 bearings) to this we add the nessie plugs

I checked that there are no rustles between each piece

But when I start the calculation I have  in the preparation window the message follows "abnormal end of the solver" and below a command "check geometry"

and when I do a geometry check everything is fine so I really don't know where to find my solution.

What should I do?

Thank you for your answers 

Damien

1 Like
2

It's with the Flow Simulation add-in I guess.

You have to look in the solver's arameters.

2 Likes
3

See this tutorial (Spanish) among others

https://www.youtube.com/watch?v=N3rQEREzYWU

@+

2 Likes
4

Thank you for your answers

Being currently short of solution I will direct my research differently, I am  at a point where my only option is to recruit someone who would be able to train me on this module so if you know someone who knows and who has 2 hours of free time and mastery of the module I am ready to pay him properly would only be for assistance!!

 

1 Like
5

The post tutorial is not enough for you?

Have you tried to follow him at least?

https://www.youtube.com/watch?v=SV5v-0HEQ9k

@+

1 Like
6

Are you under maintenance?

If so, call the hotline! That's also what it's made for!

They will ask the trainers about this module to answer you.

Otherwise consider training, the flow of fluids and the interpretation of the results are not simple.

1 Like