Hello
When exporting a sheet metal part to DXF, is there a way to set the default export of geometry + bend lines + library functions?
Indeed, the library functions are not exported by default and the risk is not to find them on the flattening.
Thank you
capture.jpg
Hello a.dufour
Batchconverter does this very well. Once the options are set, they remain so
Otherwise, in SW when exporting a sheet metal face there are the same options but I have the impression that they don't stay by default.
In SW's options, I haven't found anything about it...
Kind regards.
2021-10-26_13_27_49-batchconverter.jpg2021-10-26_13_29_08-solidworks_2021_sp4.1_-_meuble2portesbattantes.sldprt.jpg