Hello everyone,
I work on inventor and I design belt conveyors. I use a lot of sheet metal parts.
These parts are cut and bent by a subcontractor.
So I have to send him the flattens in dxf so that he can make his cutting programs.
To save time I would like to know if it is possible to automate the creation of flattening in dxf?
Thank you in advance for your answers.
Hello
I just found a utility at this address (apparently free).
https://www.cansel.ca/fr/notre-blogue/237
if it can help
Kind regards
Franck
2 Likes
well done @ Franck for your link a good apli
I don't think there is a better solution to your problem @ n.debuisson
@+ ;-)
Hello.
Your link seems to correspond well to what I expect. Unfortunately it is not compatible with my version of Inventor.
Hello
This is possible by doing a little VB programming.
If English is not a problem, the following link talks about exactly this problem, it wants to export the flattening of a sheet metal work in DXF:
http://www.mcadforums.com/forums/viewtopic.php?t=8905
What is your version of inventor?
Inventor 2010