Hello everyone,
I have a problem on a project, I want to do an extrusion offset by a few degrees on a half-cylindrical part(front view) so that when you look from above it has the shape of a diamond.
Any ideas from you are welcome,
Kind regards.
extusion_decalee.jpg
Top view diamond silhouette but side view?
Can you make a diagram with the 3 basic views?
Yes #stefbeno here is a quick trick to illustrate my idea.
Thank you
img_20190918_143727.jpg
opiep27
September 18, 2019, 12:55pm
4
- Seen from the front, you draw your half cylinder.
-from above, you draw a line with the desired inclination.
- you extrude your half cylinder, with your line on the top view as the extrusion direction.
2019-09-18__extrusion.jpg
1 Like
Thank you opiep27, it's done:)